Pinguino Forum

Full Version: PINGUINO32-DIY
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3
I got to program the bootloader without errors and I can get in to bootloader mode but when I try to load any program nothing happens, I think the the IDE that In using does not have the PIC32MX250 as a board, correct me if I'm wrong.

Thank you.
What version of the IDE are you using ?

(10-08-2012, 02:42 AM)Alfonso82 Wrote: [ -> ]I got to program the bootloader without errors and I can get in to bootloader mode but when I try to load any program nothing happens, I think the the IDE that In using does not have the PIC32MX250 as a board, correct me if I'm wrong.

Thank you.
I'm using rev.399 on win7 32bit, after hitting the program buttom I get "resetting device" message and that is it, nothing happens
Is there anybody out there that can anwser my question?
On my (non-DIY) at that point the board is reset so runs the downloaded app. If yours doesn't.... no idea!

hmm, it runs the app because no buttons are pressed (specifically, not the User button), maybe that's a clue.

John
Thank you for your answer pingot, but I need to know if the DIY board is included in the IDE rev.399 for win7.
Look in the menu where you choose the board. Look at the source code. Maybe the wiki / elsewhere says.

John
I looked in the files that got installed in my pc and I cant seem to find any file indicating that the pic32mx250f128b is included, the only files that I found are in a folder that says: "not yet used", so I´m assuming that the DIY version is no available yet. Can anyone from the Pinguino team confirm this??????
Hi

Pinguino32-DIY is only available since revision 406. I am going to build a new set of tools updated to the last revision. Of course, SVN version is OK for this board.

Regards
JP
Thank you jpmandon
Pages: 1 2 3