Pinguino Forum

Full Version: TFT touch screen
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hi all

First of all I apologise for my bad english.

Owner of an Olimex pinguino Otg board and an Itdb02 3.2 TFT I am intersted in using them with th pinguino.

This diplay with UTFT works on ChipKit Uno and Max.

I am wondering if some one tried to mount a TFT to th pinguino and what should be th wiring?
Hi,
Take a look at examples/07.Display/ITDB02 ...
Hi Regis

Thank you for your reply.
I saw this lib and exemples, and I used it with arduino

In the header from the Lib I found written by Marcus Fazzi that port D have 16bit but pinguino OTG from Olimex, port D only 12bit are wired.

To be more clear in my asking, how have I to Wire my Itead 3.2" touch TFT
Looking at the code, it seems Marcus has used these pins :

DATA PORTD are pins 0 to 7 = D0 to D7
LCD_RS PORTDbits.RD10 is pin 19 = A5
LCD_WR PORTDbits.RD9 is pin 18 = A4
LCD_CS PORTBbits.RB4 is pin 17 = A3
LCD_REST PORTBbits.RB3 is pin 16 = A2

Tell me if it works so.

(14-04-2013, 06:21 PM)jacquot Wrote: [ -> ]Hi Regis

Thank you for your reply.
I saw this lib and exemples, and I used it with arduino

In the header from the Lib I found written by Marcus Fazzi that port D have 16bit but pinguino OTG from Olimex, port D only 12bit are wired.

To be more clear in my asking, how have I to Wire my Itead 3.2" touch TFT
Thanks
I will tri thast is in 8 bit mode. Not sure if my display 16bit will work


(14-04-2013, 08:58 PM)regis Wrote: [ -> ]Looking at the code, it seems Marcus has used these pins :

DATA PORTD are pins 0 to 7 = D0 to D7
LCD_RS PORTDbits.RD10 is pin 19 = A5
LCD_WR PORTDbits.RD9 is pin 18 = A4
LCD_CS PORTBbits.RB4 is pin 17 = A3
LCD_REST PORTBbits.RB3 is pin 16 = A2

Tell me if it works so.

(14-04-2013, 06:21 PM)jacquot Wrote: [ -> ]Hi Regis

Thank you for your reply.
I saw this lib and exemples, and I used it with arduino

In the header from the Lib I found written by Marcus Fazzi that port D have 16bit but pinguino OTG from Olimex, port D only 12bit are wired.

To be more clear in my asking, how have I to Wire my Itead 3.2" touch TFT