Pinguino Forum
USB COM device - Printable Version

+- Pinguino Forum (http://forum.pinguino.cc)
+-- Forum: Hardware (http://forum.pinguino.cc/forumdisplay.php?fid=6)
+--- Forum: 8-bit (PIC18F) Pinguino (http://forum.pinguino.cc/forumdisplay.php?fid=42)
+---- Forum: Troubleshooting (http://forum.pinguino.cc/forumdisplay.php?fid=14)
+---- Thread: USB COM device (/showthread.php?tid=3106)



USB COM device - SKAR1970 - 24-10-2011

Ok, so i got the Pinguino working.

I compiled a sketch into the pinguino to send a message to the PC running windows vista 32 bit using CDC. everything is ok.
ofter rebooting the Pinguino, Windows sees a new USB device LIBUSB32 ... , Microchip cdc rs232 serial... but what it does not do is open a COM x port to this.

i.e. no new COM device is registered.

What do i need to install for this to make a com device so i can use Putty?


RE: USB COM device - regis - 26-10-2011

Hi,
I think this can help you : http://forum.pinguino.cc/showthread.php?tid=3100
RĂ©gis


(24-10-2011, 12:06 AM)SKAR1970 Wrote: Ok, so i got the Pinguino working.

I compiled a sketch into the pinguino to send a message to the PC running windows vista 32 bit using CDC. everything is ok.
ofter rebooting the Pinguino, Windows sees a new USB device LIBUSB32 ... , Microchip cdc rs232 serial... but what it does not do is open a COM x port to this.

i.e. no new COM device is registered.

What do i need to install for this to make a com device so i can use Putty?