Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Serial Device
10-02-2012, 07:16 PM,
#7
RE: Serial Device
My mistake - I was comparing with Arduino / Maple for which the IDE resets the device and the board stays in bootloader (HID) mode for a couple of seconds when the IDE will pick it up and upload the HEX file. It sounds like Pinguino does not have this facility.

Yes, it looks like a driver issue. I have gone through mails touching this subject, but did not help to solve this issue. To reinstall the driver, it should be sensed at the time of plugging, or it should show up in device list. Niether happens in my case.

I never guessed anybody here belongs to the psychic category.

I am fully aware that everybody present here are unpaid volunteers. Being unpaid volunteer does not imply that you are obliged to hammer newbies. There is no pressure on you to respond against your will.
When you don't feel like responding, my suggestion is to leave it to others.
Reply


Messages In This Thread
Serial Device - by Phisatho - 10-02-2012, 07:42 AM
RE: Serial Device - by electronlibre - 10-02-2012, 11:40 AM
RE: Serial Device - by pingotg - 10-02-2012, 01:08 PM
RE: Serial Device - by Phisatho - 10-02-2012, 03:49 PM
RE: Serial Device - by regis - 10-02-2012, 04:39 PM
RE: Serial Device - by pingotg - 10-02-2012, 06:14 PM
RE: Serial Device - by Phisatho - 10-02-2012, 07:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)