Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
8-bit total failures
11-11-2013, 12:30 PM,
#4
RE: 8-bit total failures
When you press the reset button, the user led blinks at a high frequency (T=2*43ms exactly), it means your Pinguino enters in the bootloader mode. Now, you can upload your program with no time limit. At the end of the upload, your program should start automatically.
While in bootloader mode, your Pinguino act as a USB Bulk Device. Try something like lsusb to check if your Pinguino is recognized.
Pinguino 4550 + bootloader 4.13 (or 4.12) has been tested without problem so it's maybe a hardware issue ... difficult to figure out from here.
Good luck.
It is easier to complain than it is to do, but it is better to do than it is to complain.
Reply


Messages In This Thread
8-bit total failures - by blledwards - 09-11-2013, 07:36 PM
RE: 8-bit total failures - by gtcbreizh - 09-11-2013, 10:56 PM
RE: 8-bit total failures - by blledwards - 10-11-2013, 07:18 PM
RE: 8-bit total failures - by regis - 11-11-2013, 12:30 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)