The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.2.24 (Linux)
File Line Function
/showthread.php 864 errorHandler->error

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PIC32MX250 Bootloader mode problem
17-07-2015, 12:50 PM,
PIC32MX250 Bootloader mode problem
Hi all

I can't enter in bootloader mode in a PIC32MX250F128B based DIY pinguino board.
The board is correctly recognized as a usb hid device (I used HIDBoot_MX250.hex).
I followed the boot step procedure stated in the PIC32MX250 wiki page.

1 - Press and hold down the user button BUT (Pin 3 of the IC)
2 - Press and release the user button RST (Pin 1 of the IC)
3 - Release the user button BUT

The USERLED blinks but the IDE doesn't recognize the board and ask for enter in bootloader mode to load the new program. No matters how many times I repeat the bootloader procedure, the IDE is not able to detect the board.
I have tested the PIC32MX250F128B IC with a program for CDC communication developed with MPLABX and works fine.

I'm also using a 8 bits pinguino board based in the PIC18F4550 without a problem, so it's seems to be a problem with PIC32 and Pinguino IDE.

I'm using Pinguino IDE V11 release 06/07/2015 on Windows 7 x64.

I hope that someone can help me to solve this problem.



Messages In This Thread
PIC32MX250 Bootloader mode problem - by Leonardo - 17-07-2015, 12:50 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)