The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.2.23 (Linux)
File Line Function
/showthread.php 864 errorHandler->error

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ECCP1 on 18F45K50
19-11-2018, 08:13 PM,
ECCP1 on 18F45K50

I am trying to get the enhanced CCP module to work with the 18F45K50 but so far I only see the modulated P1A pin. 

As I failed to successfully configure the PIC under Mplabx 5.10, btw., no serious problems with 18F4550 here, I searched for example programs and come across HBridge_18F4550.pde which compiled and after importing the hex file into Mplabx, it showed traces on P1A and other pins using the logic analyser of the simulator. I then compiled the same code for the 18F45K50, making a small adjustment for the oscillator setting in config.h, and still, I only see the modulated P1A in the simulator.
Has anybody had any success in getting the ECCP module to work in Half-Bridge or Full-Bridge mode and if so, can you help ?

Messages In This Thread
ECCP1 on 18F45K50 - by richard.avilez - 19-11-2018, 08:13 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)