Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
G-Code interpreter
11-07-2012, 11:39 PM,
#11
RE: G-Code interpreter
Someone have progress in this develop??? now i have 2 weeks to complete my cnc, i finish all structure, and electronics... to control the steppers use this board http://www.sparkfun.com/products/10267 now... need program all software...
Reply
12-07-2012, 06:36 AM,
#12
RE: G-Code interpreter
I found this... http://txapuzas.blogspot.com/2009/12/txa...tware.html this is a greate software, i think this is a greate code for arduino and have a big solution in gambas...

But this code is written for Arduino, and obiamente we need is for Pinguino, in this sense I did this on github repository where the code will stay, still in development https://github.com/aasanchez/G-Code-for-Pinguino for now I have a problem that perhaps can guide me ... to_steps is in the function, which gives the following error error 101: too many parameters but you can see is being used correctly ... any solution?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)