Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to control LED2 on PIC32 Pinguino-OTG?
07-01-2013, 09:44 PM,
#11
RE: How to control LED2 on PIC32 Pinguino-OTG?
John,

I have used LED1 /2 and GREENLED / YellowLED and they work, my problem is I can not figure out if I wanted to use a port output say F1, I can not find the relavents to F1 and 50 or 51.... etc.

Do you have a link to the Xref doc, I looked in wiki, thought the IO Mapping / Pin numbers would have had it but I could not find it there.

Thanks
Terry
Reply
08-01-2013, 01:36 AM, (This post was last modified: 08-01-2013, 01:39 AM by pingotg.)
#12
RE: How to control LED2 on PIC32 Pinguino-OTG?
Ah. I think you've made an easy mistake. On that wiki page there are 2 columns headed I/O Diagram and Table. Under Table is the Xref PDF for the OTG and it'll do nicely for your board.

If I manage to post it properly here's a link OTG pin etc Xref

Mark and I had a few emails sorting it out but all I did was tweak it (I had a cruder version with about half as much in it).

John
Reply
08-01-2013, 04:29 PM,
#13
RE: How to control LED2 on PIC32 Pinguino-OTG?
John,

Thanks that helps.

Big Grin
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)