Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
show timer1 ticks
01-01-2012, 04:57 PM,
#1
show timer1 ticks
... continue exploring direct iron hardware...

arturo

(if there is a better place to post this, please correct me)



Attached Files
.pdf   show timer1 ticks.pdf (Size: 20.01 KB / Downloads: 11)
Reply
01-01-2012, 07:10 PM,
#2
RE: show timer1 ticks
Hi Arturo,
Just one thing, instead of :
Serial.Configure(UART1, UART_ENABLE, UART_RX_TX_ENABLED, 115200);
you can also simply used the Arduino syntax :
Serial.begin(115200);
it will use the same config by default (UART1, ...)
Enjoy.
Régis

(01-01-2012, 04:57 PM)arturo.tramontini Wrote: ... continue exploring direct iron hardware...

arturo

(if there is a better place to post this, please correct me)

It is easier to complain than it is to do, but it is better to do than it is to complain.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)