Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pic32 Interrupts
28-06-2012, 08:50 AM,
#41
RE: Pic32 Interrupts
Could be useful!

What's connected to port C to receive the signal?

John
Reply
28-06-2012, 12:01 PM,
#42
RE: Pic32 Interrupts
I connected a small remote control test board with 4 outputs that I was given at the EMBEDDED show.

I see you can also buy the current version of the device: http://de.mouser.com/ProductDetail/Silic...CuyU658AXb

I just soldered a wire before each LED and feed the signal into the inputs of the Pinguino. No programming required at all.

/M
Reply
28-06-2012, 12:41 PM,
#43
RE: Pic32 Interrupts
Nice thing to get free!

John
Reply
19-04-2013, 02:31 PM,
#44
RE: Pic32 Interrupts
regarding the code on the first page of this thread that PJ Mandon wrote, I used it on the Pinguino OTG board, (with PIC32MX440), and it does not seem to do nothing when trying to activate the interrupt by connecting a line from 3.3 (or 5) V to D7, which is the INT4 pin according to the datasheets. I am wondering if this code, which was meant for the MX220, will also work for the MX440?

I would appreciate some light on this! Smile
Reply
06-09-2017, 01:17 AM,
#45
RE: Pic32 Interrupts
(19-04-2013, 02:31 PM)RobertoB Wrote: regarding the code on the first page of this thread that PJ Mandon wrote, I used it on the Pinguino OTG board, (with PIC32MX440), and it does not seem to do nothing when trying to activate the interrupt by connecting a line from 3.3 (or 5) V to D7, which is the INT4 pin according to the datasheets. I am wondering if this code, which was meant for the MX220, will also work for the MX440?

I would appreciate some light on this! Smile

Hi RobertoB. Did you get any further with getting interrupts working on the MX440?  I am also having trouble with this and getting the compiler to work! Thanks, Michael
Reply
07-09-2017, 04:47 PM,
#46
RE: Pic32 Interrupts
Hi Mickael,
What's the problem exactly ?
Regis
It is easier to complain than it is to do, but it is better to do than it is to complain.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)