Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HOW TO UPLOAD file.hex from Pinguino to DUINOMITE-MEGA
03-04-2013, 09:53 AM,
#1
HOW TO UPLOAD file.hex from Pinguino to DUINOMITE-MEGA
Good Morning,

I'm writing this post for asking you if Pinguino can really upload file.hex to a Duinomite-MEGA.


I used both of them (Pinguino/USBBootloader) but no success Sad .

To convert to file.hex I used UBW32 795 as board config.


The duinomite-MEGA has a PIC32MX795 microcontroller .


Thank you to pay attention at my post . Have a nice day Wink !


Attached Files Thumbnail(s)
   
Reply
03-04-2013, 10:43 AM,
#2
RE: HOW TO UPLOAD file.hex from Pinguino to DUINOMITE-MEGA
You may need a pinguino bootloader. You can use a PICkit 2 or 3 to write one and they're quite cheap especially on ebay.

Overall: it's possible but the board may not already have support so you may have to add it (change digitalw.c and so on).

John
Reply
03-04-2013, 12:59 PM,
#3
RE: HOW TO UPLOAD file.hex from Pinguino to DUINOMITE-MEGA
(03-04-2013, 10:43 AM)pingotg Wrote: You may need a pinguino bootloader. You can use a PICkit 2 or 3 to write one and they're quite cheap especially on ebay.

Overall: it's possible but the board may not already have support so you may have to add it (change digitalw.c and so on).

John

I tried to modify analog.c const.h digitalw.c and spi.c . but still it doesn't work Sad


When I'm using the USB Bootloader v2.90a but It says

"No address within range in file: volmeter.hex. Verify the correct firmware image was specified and is designed for your device."

and with Pinguino it says :

"C:\PinguinoX.3\win32\p32\bin\mphidflash.exe Error: Device not found (is device attached and in Bootloader mode?)"
Reply
03-04-2013, 08:37 PM,
#4
RE: HOW TO UPLOAD file.hex from Pinguino to DUINOMITE-MEGA
Seems more and more that you may need a pinguino bootloader.

John
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)