Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I2C 18F4550
08-11-2015, 07:05 PM,
#21
RE: I2C 18F4550
André


how do you install the resistor? i noticed something in your photo but it is not clear enough.
thanks 
fred
Reply
08-11-2015, 07:11 PM, (This post was last modified: 08-11-2015, 07:49 PM by gtcbreizh.)
#22
RE: I2C 18F4550 "SOLVED"
(08-11-2015, 07:05 PM)derf158 Wrote: André


how do you install the resistor? i noticed something in your photo but it is not clear enough.
thanks 
fred

André
it works i figured it out from your photo the 2.2k ohm go from +5v to SLC & SDA.
thank you
fred
Reply
08-11-2015, 07:51 PM,
#23
RE: I2C 18F4550
(08-11-2015, 07:11 PM)derf158 Wrote:
(08-11-2015, 07:05 PM)derf158 Wrote: André


how do you install the resistor? i noticed something in your photo but it is not clear enough.
thanks 
fred

André
it works i figured it out from your photo the 2.2k ohm go from +5v to SLC & SDA.
thank you
fred

I am very happy for you to have succeeded thanks to your stubbornness.

In a previous message I have indicated how to connect the resistors  Wink
Soon for a new adventure !
André
Reply
09-11-2015, 01:16 PM,
#24
RE: I2C 18F4550
(08-11-2015, 07:51 PM)gtcbreizh Wrote:
(08-11-2015, 07:11 PM)derf158 Wrote:
(08-11-2015, 07:05 PM)derf158 Wrote: André


how do you install the resistor? i noticed something in your photo but it is not clear enough.
thanks 
fred

André
it works i figured it out from your photo the 2.2k ohm go from +5v to SLC & SDA.
thank you
fred

I am very happy for you to have succeeded thanks to your stubbornness.

In a previous message I have indicated how to connect the resistors  Wink
Soon for a new adventure !
André
i did miss this Andre`


N.B. The SDA and SCL pins (RB0, RB1) are firstly connected to a 5V source thru 2.2K ohm resistor and secondly to the SDA and SCL pins on the I2C module.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)