Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how to use int64_t type in PinGuino
26-07-2013, 09:47 AM,
#11
RE: how to use int64_t type in PinGuino
I've updated the Wiki.
u64 and s64 are for PIC32MX only. SDCC doesn't support 64-bit type for PIC18F.

(24-07-2013, 09:26 PM)iyahdub Wrote: I was actually looking into variable type defs of the pic32 last few days, and its min/max values ( limits.h). Microchip advises you to use the ones in stdint.h is you need fixed values, given its based on GCC, and therefore has to complay with ANSI and CCI standards .
Pinguino is a project based on the good will and time availability of the community ! For which we all give thanks for !
So, there is a lot to be done, still... But, im sure you will learn a lot by doing some research, and become a better programmer and designer in the process.
Personally i love doing it !
Wink
It is easier to complain than it is to do, but it is better to do than it is to complain.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)