Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How connect MRF24J40 module with the UEXT connector OLIMEX Pinguino32 board.
16-07-2011, 09:33 PM,
#1
How connect MRF24J40 module with the UEXT connector OLIMEX Pinguino32 board.
I think the way to connect the MRF24J40 module with the UEXT connector OLIMEX Pinguino32 board is the following.


UEXT ------> MRF24J40

1 3.3 ------> 10 Vin
2 GND ------> 1,11,12 GND
3 TX2 ------> 3 WAKE
4 RX2 ------> 4 INT
5 A5 ------> 5 RESET'
6 A4 ------> NC
7 D12 ------> 7 SDO
8 D11 ------> 5 SDI
9 D13 ------> 6 SCK
10 CS ------> 8 CS'
NC ------> 9


Anyone can confirm me?

Thanks.
Reply
31-07-2011, 08:16 PM,
#2
RE: How connect MRF24J40 module with the UEXT connector OLIMEX Pinguino32 board.
Hi,

Sorry I was away since my come back from Campus Party !!

You can find all the information on the wiki page:
http://wiki.pinguino.cc/index.php/With-Z...24J40MA%2B

I think everything is there to build your own zigbee module.

JP

(16-07-2011, 09:33 PM)kankoo Wrote: I think the way to connect the MRF24J40 module with the UEXT connector OLIMEX Pinguino32 board is the following.


UEXT ------> MRF24J40

1 3.3 ------> 10 Vin
2 GND ------> 1,11,12 GND
3 TX2 ------> 3 WAKE
4 RX2 ------> 4 INT
5 A5 ------> 5 RESET'
6 A4 ------> NC
7 D12 ------> 7 SDO
8 D11 ------> 5 SDI
9 D13 ------> 6 SCK
10 CS ------> 8 CS'
NC ------> 9


Anyone can confirm me?

Thanks.

Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)