Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bootloaders
21-02-2016, 07:29 PM,
#11
RE: Bootloaders
Still looks the wrong name.

John
Reply
22-02-2016, 03:28 AM, (This post was last modified: 22-02-2016, 04:02 AM by jwzumwalt.)
#12
RE: Bootloaders
When you finally get a bootloader working, please post how you did it. Since I own the same board, I am curious what eventually works for you. The official release for Pinguino.cc bootloader is here https://github.com/PinguinoIDE/pinguino-bootloaders/tree/master/p32/usb


Please confirm you are following the proper button release procedure
To place the pic in programming mode make sure...
  1) hold both buttons down for 1sec
  2) release the button closest to the ICSP connector, wait for the blinking lights
  3) then release the button closest to the SD card


If you release the buttons in the wrong order, it does not enter programming mode.

PINGUINO.CC
There is a thread on installing the bootloader on the Olimex forum here
https://www.olimex.com/forum/index.php?topic=5068.0
and here
https://www.olimex.com/Products/Duino/PI...evised.pdf

MPIDE
Since Olimex switched to MPIDE new information on using the MPIDE bootloader is here
https://www.olimex.com/wiki/MPIDE
----------------
Thanks,
j
wzumwalt
 (\__/)
 (='.'=)
 (")_(")
Reply
24-03-2016, 02:16 AM,
#13
RE: Bootloaders
Today, Olimex provided the working Pinguino Bootloader for the PIC32 Micro...and I discovered the LibUSB-Win32, which is a small program provided in the Pinguino Installation Folder. The Bootloader is easily recognized on Win7, "Devices and Printers" as a USB HID BOOTLOADER". BUT to be recognized by PINGUINO one must run LibUSB and 'filter' the Bootloader. To identify the Bootloader in LibUSB, one must find its 'Hardware Ids", which means opening the HID-complaint device Properties window and set the Property to "Hardware Ids".
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)