Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
new: RoboPIC 18F4550 Pinguino compatible development board for robotics
02-08-2016, 04:01 AM, (This post was last modified: 02-08-2016, 04:06 AM by mikronauts.)
#11
RE: new: RoboPIC 18F4550 Pinguino compatible development board for robotics
Hi,

The whole top layer is ground, and the traces to the oscillator are short and on the bottom layer. The 22nf caps for the oscillators have short taces to the xtal (one each side) the other to the gnd plane. Similar trace for the vusb cap.

Regards,

Bill
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)