Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
trouble programming 2550 board, ubuntu 16, 32
10-03-2017, 03:39 PM,
#1
trouble programming 2550 board, ubuntu 16, 32
Greetings, I have some problems, pinguino runs and compile fine, but, not programming the device board: 2550.

lsusb -v
Code:
Bus 006 Device 050: ID 04d8:feaa Microchip Technology, Inc.
Couldn't open device, some information will be missing
Device Descriptor:
 bLength                18
 bDescriptorType         1
 bcdUSB               2.00
 bDeviceClass          255 Vendor Specific Class
 bDeviceSubClass       255 Vendor Specific Subclass
 bDeviceProtocol       255 Vendor Specific Protocol
 bMaxPacketSize0        64
 idVendor           0x04d8 Microchip Technology, Inc.
 idProduct          0xfeaa
 bcdDevice            4.14
 iManufacturer           1
 iProduct                2
 iSerial                 0
 bNumConfigurations      1

This is the output:

Code:
>>> [INFO] Compiling: /home/user/pinguino-desarrollo/Blink.pde
[INFO] Board: Pinguino 2550
[INFO] Proc: 18f2550
[INFO] Arch: 8
[INFO] Bootloader: boot4
[INFO] Compilación terminada
[INFO] Code size: 1274/29696 bytes (4.00% used)
[INFO] 1.100 seconds process time
[INFO] Looking for a Pinguino device ...
[INFO] Pinguino found ...
[DEBUG] Traceback (most recent call last):
 File "/opt/pinguino/v12/pinguino/qtgui/ide/methods/decorators.py", line 281, in wrapped
   return fn(Pinguino, *args, **kwargs)
 File "/opt/pinguino/v12/pinguino/qtgui/ide/methods/decorators.py", line 25, in wrapped
   return fn(Pinguino, *args, **kwargs)
 File "/opt/pinguino/v12/pinguino/qtgui/ide/methods/core.py", line 863, in pinguino_upload
   uploaded, result = self.pinguinoAPI.upload()
 File "/opt/pinguino/v12/pinguino/qtgui/pinguino_core/pinguino.py", line 137, in upload
   data = self.__upload__()
 File "/opt/pinguino/v12/pinguino/qtgui/pinguino_core/pinguino_tools.py", line 297, in __upload__
   result = self.upload_hex()
 File "/opt/pinguino/v12/pinguino/qtgui/pinguino_core/uploader/uploader.py", line 233, in upload_hex
   self.uploader.uploadDevice(self.hex_file, self.board)
 File "/opt/pinguino/v12/pinguino/qtgui/pinguino_core/uploader/uploader8.py", line 612, in uploadDevice
   device = self.initDevice(device)
 File "/opt/pinguino/v12/pinguino/qtgui/pinguino_core/uploader/uploader.py", line 160, in initDevice
   sys.exit("Could not set configuration: %s" % str(e))
SystemExit: Could not set configuration: [Errno 5] Input/Output Error

some ways: as root, sudo... but nope...


Attached Files Thumbnail(s)
   
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)